Follow the steps below to configure a static IP address on your device.
1. Press
Options/Menu.2. Press
Page Down twice.
3. Select
Data Centre Options.4. Press
Page Down.5. Select
Network Settings.6. Select
Get IP.7. Select
Specify Address Manually.8. Select
IP, then press
C to clear the existing entry. Key in your static IP address. Press
Enter or
Accept to confirm the new setting.
NOTE: Key in the complete IP address, including the decimal points separating the IP address parts. If one or more sections contain less than 3 digits, use zeros to fill. e.g. 192.168.1.25 should be entered as 192.168.001.025.
9. Select
Subnet Mask/Subnet, then, press
C to clear the existing entry. Key in your subnet mask settings in the same way as the IP address. Press
Enter or
Accept to confirm.
10. Select
Default Gateway/ Gateway, then, press
C to clear the existing entry. Key in your default gateway in the same way as the IP address above. Press
Enter or
Accept to confirm.
11. If requested, press
Enter again to confirm the settings.
12. Press the
Home key to exit the setup menu.
UPDATED: February 11, 2021