Skip to main content
Print this support article

Moving the DM50-DM60

Instructions on how to physically move the DM50/DM55 (K721) and DM60 (K722).
Products affected: DM50™, DM55™ (K721), DM60™ (K722)
If you need to move your DM50/DM55 or DM60 franking machine, whether its across the room or to a new facility, a few precautions need to be taken.  Follow these steps to move it safely.
 
  1. Remove the ink cartridge:
    1. Press the Menu / Options key.
    2. Press Review (down) until the message Use ink functions? is displayed.
    3. Press Enter/Yes.
    4. Press Review (down) until the message Replace ink cartridge? is displayed.
    5. Press Enter/Yes.
    6. Open the top cover.
    7. Press the top of the ink cartridge latch located on the green unlock icon.
    8. Remove the ink cartridge and place it in a zip-top bag, as it may leak in transport.
  2. Unplug the power cord and close the cover.
  3. Unplug the scale from the back of the franking machine and remove it from the top of the franking machine.
Note: When you move the franking machine, make sure that it stays level or ink may leak and damage the franking machine.
  1. Reinstall the ink cartridge.
Note: This must be done before applying power to the franking machine.
  1. Plug the scale into the back of the meter and place it on the top of the franking machine.
  2. Plug the power cord into the franking machine and power outlet.

If you need any information about size, power requirements, other product specifications, see the Features & Specs section under the DM60 franking machine.

UPDATED: 14 August 2021