Adding or changing an envelope text message or return address on the Connect+ series and SendPro P
Products affected: Connect+ 500W, Connect+ 1000, Connect+ 2000, Connect+ 3000, SendPro P1000, SendPro P1500, SendPro P2000, SendPro P3000
- From the Run Mail screen, select Edit Envelope.
- Select Text messages and Return addresses.
- To create a new text message, select New at the bottom of the screen.
- Enter your text message.
- Select Save.
- Name the text message.
- Select OK.
Note: You can store up to 20 text messages.
- If there is no message/address currently displayed on the envelope, select one of the available messages from the Edit envelope screen. A tick box appears next to the selected message.
- To change the position of the message, use the Green Position Arrows on the right side of the screen.
- To remove the message/address, deselect it.
- Select OK.
UPDATED: December 30, 2016
