Installing a HP TFT7600 KVM

print
Product Feature: General

Operating System: All Windows Platforms

Database: All Oracle Versions

Configuration: HP Proliant Servers
 

Installing the HP TFT7600 G2 Rackmount Keyboard Monitor KVM Console

  1. Align the HP 1U Adjustable Toolless Rails with the holes marked on the rack, and snap them into place.

    1. Snap one end of the HP 1U Adjustable Toolless Rails into the retna rails.

    2. Extend the other half of the HP 1U Adjustable Toolless Rails to meet the appropriate rack depth, and snap them into place.

      NOTE: If the HP 1U Adjustable Toolless Rails do not snap into place, be sure that they align with the holes marked on the rack. The holes marked on the rack must be in the same location for the front and rear of the rack.
      User-added image
  2. Extend the inner slides until they lock into place.

  3. Align the unit with the extended inner slides, and then insert the unit into the rack.

    User-added image
  4. From the rear of the rack, slide the brace rail assembly in between the HP 1U Adjustable Toolless Rails.

    User-added image
  5. Align the screw holes on the brace rail with the screw holes on the HP 1U Adjustable Toolless Rails.
     

  6. Using two 6-32 screws, secure the brace rail to the HP 1U Adjustable Toolless Rails.

    User-added image
  7. Remove and discard the two shipping screws from the rear of the unit.

    User-added image
  8. Attach the cable management arm to the rear of the unit with two 6-32 screws.

    User-added image
  9. Connect and route the cables through the cable management arm and unit opening.
    User-added image

     

UPDATED: March 25, 2015