Assembling the AddressRight 100 printer

Learn how to assemble the AddressRight 100 printer.
Products affected: AddressRight® 100 Printer

Tools required

  • Standard #2 Phillips head screwdriver

Follow these steps to assemble the printer:

  1. Installing the Side Guides
  2. Installing the Rear Media Support
  3. Installing the Rear Media Guide

1 Installing the Side Guides

  1. Remove the two screws from the side guide blocks.
  2. Position the side guide screw holes so that they align with the holes in the side guide blocks.
  3. Insert the screws removed in step 1. Tighten the screws so that the guides are firmly attached to the side guide blocks [A].
    ar100-install-side-guides_416x198

2 Installing the Rear Media Support

  1. Install the rear media support onto the rear center plate using the three screws [A] (included).
    Install Rear Media Support_1_288x227

3 Installing the Rear Media Guide

  1. Insert adjusting knob [A] through the rear media guide and rear media support and screw it into the rectangular washer [B].
    Install Rear Media Support_289x385

UPDATED: 23 April 2022

Contact Us
Email
Report an issue from your inbox.
13 23 63
Mon – Fri, 8am - 5pm (Ex. Public Holiday)