Adding or changing a text message or return address on the Connect+ Series

Print this support article
Products affected: Connect+® 500W, Connect+® 1000, Connect+® 2000, Connect+® 3000
  1. From the Run Mail screen, select Edit Envelope.
  2. Select Text messages and Return addresses.
  3. To create a new text message, select New at the bottom of the screen.
  4. Enter your text message.
  5. Select Save.
  6. Name the text message.
  7. Select OK.

    Note: You can store up to 20 text messages.

  8. If there is no message or return address currently displayed on the envelope, select one of the available messages from the Edit envelope screen. A check box appears next to the selected message.
  9. To change the position of the message, use the Green Position Arrows on the right side of the screen.
  10. To remove the message or return address, deselect it.
  11. Select OK.

UPDATED: 22 April 2021