Skip to main content
Related Search Topics: Maintenance Printing
Print this support article

Printing a test label print on the PB-SP100 Printer

Printing a test label can check whether the printer has any problems.
Products affected: SendKit PB-SP100 Label Printer

Print a test label can check whether the printer has any problems.

To print a test print

  1. Make sure that the label roll has been installed properly.
Note: See Changing the Label Roll on the 1E42 and PB-SP100 Printers for information on correctly doing this.
  1. Turn on the power while holding down the Feed/Cancel button sp-100-feed-cancel-button_21x21 until the test label begins to print. This may take around 10 seconds.

The test label with show the current printer configuration information. After the self-test results are printed, a printer enters into print ready mode.

UPDATED: 19 December 2024