Setting up a wireless (WiFi) connection with a SmartLink device on the mailstation2 and DM125-DM475

Print this support article
Products affected: mailstation2™, DM125™, DM300C™, DM400C™, DM475™
To configure a wireless (WiFi) connection using a SmartLink™ device:
  1. Wireless setup requires you to go to the SmartLink Setup page.
    1. Select Wireless under 'Choose Your Connection
    2. Follow the directions to configure your wireless connection.
  2. After configuring your wireless connection:
    • If the light on your SmartLink device blinks green, then you are done connecting your SmartLink device.
    • If the light on your SmartLink device does not blink green after 3 minutes, see the Wireless Internet Troubleshooting section on the SmartLink troubleshooting page.

Use the Contact Us options below if you need further assistance.

UPDATED: 14 August 2021