Sealing Envelopes on the SendPro C Auto
Applies to SendPro C Auto models with PCN 9H00
Products affected: SendPro® C Auto (9H10)
This procedure describes how to seal envelopes whether you are printing postage on the envelopes or only sealing the envelopes (no postage).
- Check the level of sealing solution by checking the sight window on the front of the feeder deck.
- Place the envelopes with the flap side facing down and the top edge against the rear wall.
-
Make sure the seal/no seal lever is set to the seal position (all the way to the left) as shown here.
- Place the envelopes on the feed deck and tap the Start button on the Envelope Printing screen.
Note: If the moistener tank is full and your envelopes do not seal correctly, clean or replace the moistener brush and wick.
Related topics
UPDATED: 04 November 2021
Contact Us
Live Chat
Available • Closes at 8pm ET
Sales team hours are 8am-6pm ET
Sales team hours are 8am-6pm ET
Live Chat
Live Chat is currently unavailable.
Chat is available Mon-Fri, 8am-8pm ET
Chat is available Mon-Fri, 8am-8pm ET
Create a case
Submit support requests
(Sign in required)