How to fill the moistener on the DM100i and DM125

Print this support article
Products affected: DM100®i and DM125™
NOTE: E-Z Seal® solution is recommended because it helps keep the moistener clean and improves sealing efficiency
  1. Check the level of sealing solution in the moistener tank.
  2. Add enough solution to bring the sealant level up to the bottom of the fill hole. Do not overfill the tank.
  3. If the tank is empty, allow 30 minutes for the moistener brush and wick to get completely saturated.
Check the level of sealing solution in the moistener tank

UPDATED: 30 June 2021