Error Code: 031A410009, How to resolve on the Connect+ 500W, Connect+ 1000, and more

Print this support article
Products affected: Connect+ 500W®, Connect+ 1000®, Connect+ 2000®, and Connect+ 3000®

Issue

The Connect+ displays error code 031A-41-0009, and will not print.

Cause

The length sensor calibration failed.

Resolution

A reboot may resolve the issue.
  1. Select the green house at the top of the screen to go to the home screen
  2. Select Shut Down from the lower right corner
  3. Select Shut Down from the menu
  4. Select Shut Down on the pop up
  5. Wait for the screen to go black and the blue light on the front to go out. This may take several minutes.
  6. After everything has been off for 10 seconds press the power button to power the Connect+ back up​
Note: You should perform a shut down nightly using the shut down icon, not the power button at the front of the equipment

If your issue is not resolved or unable to access the home page, contact customer support from 8 am to 8 pm Eastern Time. Have your model number ready.

UPDATED: 14 August 2021