Filling the moistener tank on the SendPro C, SendPro+

Print this support article
Products affected: SendPro® C, SendPro®+ (2H00, 8H00)

Your device will need refills of E-Z Seal® in order to seal envelopes. Follow these steps to fill the moistener tank.

  1. Check the level of E-Z Seal® in your moistener tank (1).
    Moistener tank showing where to check level and fill
  2. Add enough E-Z Seal® to bring the sealant level up to the bottom of the fill hole (2). Do not overfill the tank.
  3. If the tank is empty, allow 30 minutes for the moistener brush and wick to get completely wet.

UPDATED: July 22, 2021