Troubleshooting the Datamax MK III label printer in PitneyShip, PitneyShip Pro, or PitneyShip Enterprise

Products affected: PitneyShip®, PitneyShip® Pro, PitneyShip® Enterprise

There are several things you can try if the Datamax MK III printer is not printing properly, or if the red light is flashing.

In this article:

Poor print quality

If the print quality is poor, try changing this setting.

  1. Click Windows Start.
  2. Open Control Panel.
  3. Right-click on the Datamax MK III printer and choose Printer Preferences.
  4. Click the Graphics tab.
  5. Set Dithering to None.
  6. Click OK.

Not printing

If the printer is not printing at all, try the following solutions.

Solution 1: Ensure that the printer driver is installed

For instructions, see:

Solution 2: Reinstall the paper roll

With the roll sitting between the two green pressure brackets [1], make sure of the following:

  • The roll feeds from the top
  • The labels are facing up and the glossy backing paper is facing down
  • The roll feeds under the two green guides [2]
  • The leading end of the roll rests on the black and green roller [3] inside the printer

If the leading end of the roll sticks out of the printer when the cover is closed, press start/pause on the cover of the printer once. This causes the leading end of the roll to position itself at the end of the container.

Datamax Mark III printer rollers, guides, and brackets

Red light is flashing

If the red light on the printer is flashing, try these solutions.

Solution 1: Check the printer cover

Ensure that the printer cover is closed tightly.

Solution 2: Ensure that the correct roll is being used

The correct roll for the Datamax MK III printer is 6WB-F.

Solution 3: Reinstall the paper roll

Reinstall the roll as described above.

Solution 4: Turn the printer off and back on

  1. Turn the printer off for 30 seconds.
  2. Turn the printer back on.

Running a test print

To test the printer, you can run a test print.

  1. Select the Windows Start > Devices and Printers.
  2. Right-click the Datamax-ONeil Mark III printer and select Printer Properties.
  3. Select the General tab.
  4. Select Print Test Page.

If you cannot run a test print from the printer, then the issue is with the printer itself. Contact your local IT department or the printer manufacturer.

The features and options you see may vary depending upon your role and subscription. If you have any questions regarding your permissions, please contact your administrator.

UPDATED: November 20, 2026