Installing the printhead on the SendPro C Lite, SendPro C, SendPro+, SendPro C Auto

Print this support article
Products affected: SendPro® C Lite, SendPro® C, SendPro®+, SendPro® C Auto  (2H00, 8H00, 9H00)
You may need to install a new printhead when the existing printhead is producing poor print quality.
  1. Tap Settings on the toolbar.
    Settings icon
  2. Scroll down and tap Envelope Printer Maintenance or Mail Printer Maintenance
  3. Tap Install Printhead.
  4. Lift the cover; the ink cartridge moves to the front position.
  5. Flip the ink cartridge guard open.
  6. Remove the ink cartridge as shown on the label to the right of the cartridge holder.
  7. Squeeze the two gray tabs on either side of the printhead.

    Printhead tabs location

  8. Lift and tilt the printhead gently to the right.

    Orient printhead for removal

  9. Pull the old printhead up and out of the holder.

    Removing the printhead

  10. Note the location of the plastic alignment tabs and the orientation of the printhead so that you can install the new printhead correctly.

    Printhead alignment tabs

  11. Examine the printhead holder and find the location of the lower printhead alignment slots.

    Printhead alignment slots

  12. Insert the printhead by squeezing the tabs on either side of the printhead and sliding the plastic alignment pins into the lower slot of the printhead holder.

    Reinsert printhead

  13. Gently push the printhead into place until it snaps into position.
  14. Install the ink cartridge (see the label to the right of the cartridge holder).
  15. Rotate the guard back to the closed position.
  16. Close the cover; the ink cartridge moves back to the original position.
  17. Tap Done.
  18. Print a print test pattern to be sure that your printhead is working properly.
If you need further assistance, please use the Contact Us options below.

UPDATED: June 08, 2021