How to add or change an envelope text message on the Connect+ series and SendPro P series

Products affected: Connect+® 500W, Connect+® 1000, Connect+® 2000, Connect+® 3000, SendPro® P1000, SendPro® P1500, SendPro® P2000, SendPro® P3000
Follow these steps to add or change an envelope text message:
  1. From the Run Mail screen, select Edit Envelope.
  2. Select Text messages and Return addresses.
  3. To create a new text message, select New at the bottom of the screen.
  4. Enter your text message.
  5. Select Save.
  6. Name the text message.
  7. Select OK.
Note: You can store up to 20 text messages.
  1. If there is no message/address currently displayed on the envelope, select one of the available messages from the Edit envelope screen. A check mark appears next to the selected message.
  2. To change the position of the message, use the Green Position Arrows on the right side of the screen.
  3. To remove the message/address, deselect it.
  4. Select OK.

UPDATED: December 30, 2016