How to load a high capacity sheet feeder tray on the DI900, DI950, and Relay 5000-8000

Print this support article
Products affected: DI900™, DI950™, Relay™ 5000, Relay™ 6000, Relay™ 7000, Relay™ 8000
To load sheets into the HCSF:
  1. After loosening the pages of the stack of sheets, turn the HCSF Tray Side Guide Adjuster counterclockwise to open the Tray wide enough to accommodate the stack of sheets.
NOTE: The Side Guide Adjuster is located below the tray indicator letter.
  1. Load approximately 1 inch of material into the Tray in the orientation specified in the loading instructions on the Home screen. Green lights on the front panel of the HCSF indicate that the material is loaded and that the HCSF is operable.
  2. Turn the Feeder Tray’s Side Guide Adjuster clockwise until the side guides touch the material, and then back off slightly.
If you require additional assistance, contact technical support. Please have your model and serial number ready.

UPDATED: August 14, 2021