How to tear continuous unpeeled labels on a JZ30 Label Printer used with SendSuite Live

Learn how to tear continuous unpeeled labels on a JZ30 Label Printer used with SendSuite Live.
Products affected: SendSuite® Live
Watch this video and follow the instructions below to learn how to properly tear off a label when using continuous label stock and bypassing the peeler feature on the JZ30.

Application:

  • Continuous stock
  • Not peeling
  • Present sensor disabled
     
  1. After properly loading the media according to the manufacturer’s instructions, open the peeler assembly by pulling towards the front of the printer the yellow handle on the front right of the label dispensing area. Allow the peeler assembly to rest in the open position.
  2. Produce a label.
  3. In a single motion, pull down and across to create a clean tear and remove the label from the dispensing area.

UPDATED: November 04, 2021

Contact Us
Live Chat
Available • Closes at 8pm ET
Sales team hours are 8am-6pm ET
Live Chat
Live Chat is currently unavailable.
Chat is available Mon-Fri, 8am-8pm ET
Create a case
Submit support requests (Sign in required)