The inserter is displaying error 51 Remove material from: Folder Area when material enters the folder and will not run.
Material is jammed in the folder.
To resolve this issue:
- Remove any partially fed material from the feed trays.
- Open the front cover.
- Check for jams in the folder (area above knob 3).
- Closed all jam release knobs and covers.
- Press Cancel to clear the error.
- Press Clear Deck to remove any material that is still in the system.
- Verify that the correct material is loaded for this job.
Note: To check the loading directions, select Loading Directions and Pre-Run Adjustments on the job screen.
If the issue is not resolved or if the issue returns, contact customer support from 8 am to 8 pm Eastern Time. Please have your model number ready.
UPDATED: November 03, 2016