Error 03114100DF "Jam in sealer area" message on the SendPro MailCenter, SendPro P Series or Connect+ Series

Products affected: SendPro® MailCenter, SendPro® P Series, Connect+® Series

Issue

The error 03114100DF "Jam in sealer area" appears.

Cause

There may be an issue with the moistener assembly or the envelope flaps may require extra pressure to be applied to ensure they are sealed sufficiently.

Resolution

If mail is physically jamming in the stripper blade

The stripper blade is located in the centre of the meter.
spmc-1000-2000-stripper-blade
Stripper blade 

  1. Check if sealing is on when it should be off. Select Run Mail from the Home screen.
  2. Select the Sealer icon.
    Sealer button
  3. Ensure only unsealed mail is fed when closed flap sealing is on. Use the Some envelopes are closed flap (No previously sealed envelopes) setting.

If thick mailpieces are stalling in the area of the stripper blade with no apparent jam

  1. Increase the feeder setting to a higher number.
    Thickness adjustment knob
    spmc-thickness-adjustment
  2. Ensure the speed is as high as possible without causing mail to shear. See Changing the machine speed.
  3. Pre-seal envelopes if necessary.

If mail is shearing (bunching up) as it feeds

  1. Increase the feeder setting to a higher number.
  2. If this does not work, try decreasing the speed. Note: If pieces are not shearing, slowing down the feeder could make problems worse. See Changing the machine speed.
  3. If pieces are unsealed and feeder setting and speed changes do not work, pre-seal the mail before running through the meter.

UPDATED: November 16, 2026