Adjusting the AddressRight 300 printer to the media

Print this support article
Products affected: AddressRight™ 300 Printer
  1. Place one piece of media on the center of the conveyor portion of the feeder.
  2. Adjust the side guides [1] to the media.
    Adjust Printer to Media_320x231
  3. Use the media retainer assembly [2] to help hold the media down.

Note: The two narrow belts can be moved by turning the printer on and sliding the belt guide adjusters (located under the conveyor table) in the appropriate direction until they are under the media.
Adjust Printer to Media_1_344x159

UPDATED: 14 August 2021